Using the Standard Linear Ramps of the CMS Superconducting Magnet for Measuring the Magnetic Flux Density in the Steel Flux-Return Yoke

Klyukhin, V.; Curé, B.; Amapane, N.; Ball, A.; Gaddi, A.; Gerwig, H.; Hervé, A.; Loveless, R.; Mulders, M.

Авторы: Klyukhin Vyacheslav, Curé Benoit, Amapane Nicola, Ball Austin, Gaddi Andrea, Gerwig Hubert, Hervé Alain, Loveless Richard, Mulders Martijn
Журнал: IEEE Transactions on Magnetics
Том: 55
Номер: 2
Год издания: 2019
Издательство: Institute of Electrical and Electronics Engineers
Местоположение издательства: Piscataway, NJ, United States
Первая страница: 8300504
DOI: 10.1109/tmag.2018.2868798
Аннотация: The principal difﬁculty in large magnetic systems having an extensive ﬂux-return yoke is to characterize the magnetic ﬂux distribution in the yoke steel blocks. Continuous measurements of the magnetic ﬂux density in the return yoke are not possible and the usual practice uses software modeling of the magnetic system with special 3-D computer programs. The 10 000 t ﬂux-return yoke of the Compact Muon Solenoid (CMS) magnet encloses a 3.8 T superconducting solenoid with a 6 m diameter by 12.5 m length free bore and consists of ﬁve dodecagonal three-layered barrel wheels around the coil and four endcap disks at each end. The yoke steel blocks, up to 620 mm thick, serve as the absorber plates of the muon detection system. A magnetostatic 3-D model of the CMS magnet has been developed to describe the magnetic ﬁeld outside the solenoid volume, which was measured with a ﬁeld-mapping machine. To verify the magnetic ﬂux distribution calculated in the yoke steel blocks, direct measurements of the magnetic ﬂux density with 22 ﬂux loops installed in the selected regions of the yoke were performed during the CMS magnet test in 2006 when four “fast” discharges of the CMS coil (190 s time constant) were triggered manually to test the magnet protection system. No fast discharge of the CMS magnet from its operational current of 18.2 kA, which corresponds to a central magnetic ﬂux density of 3.8 T, has been performed at that time. For the ﬁrst time, in this paper, we present measurements of the magnetic ﬂux density in the steel blocks of the return yoke based on the several standard linear discharges of the CMS magnet from the operational magnet current of 18.2 kA. To provide these measurements, the voltages induced in the ﬂux loops (with amplitudes of 20–250 mV) have been measured with six 16 bit data acquisition modules and integrated ofﬂine over time. The results of the measurements during magnet linear ramps performed with a current rate as low as 1–1.5 A/s are presented and discussed.
Добавил в систему: Клюхин Вячеслав Иванович

	ИСТИНА	Войти в систему Регистрация
	ИСТИНА ИНХС РАН
	Главная Поиск Статистика О проекте Помощь

ИСТИНА

ИСТИНА ИНХС РАН

Using the Standard Linear Ramps of the CMS Superconducting Magnet for Measuring the Magnetic Flux Density in the Steel Flux-Return Yokeстатья

Прикрепленные файлы