|
ИСТИНА |
Войти в систему Регистрация |
ИСТИНА ИНХС РАН |
||
Keyhole-induced Porosity in Laser Manufacturing Processes: Formation Mechanism and Dependence on Scan Speedстатья
- Авторы: Seidgazov R.D., Mirzade F.Kh
- Журнал: Chinese Journal of Mechanical Engineering: Additive Manufacturing Frontiers
- Том: 1
- Номер: 3
- Год издания: 2022
- Издательство: Chinese Mechanical Engineering Society (CMES)
- Местоположение издательства: China
- Первая страница: 100044
- DOI: 10.1016/j.cjmeam.2022.100044
- Аннотация: Laser welding and laser-based powder-bed fusion additive manufacturing in the deep penetration (keyhole) mode are promising technologies for the synthesis of metal components. The significant potential of these technologies remains latent because of structural defects (porosity), which significantly degrade the structural integrity and performance of the end products. Practical strategies for reducing those defects are addressed through fundamental understanding of their formation. In this study, pore formation of hydrodynamic origin is investigated, including the dynamics and mechanisms of the formation based on the above mentioned technologies. The pore volume and frequency of pore appearance, depending on the amplitude and frequency of capillary vibrations, are considered. Physical analysis is performed to obtain the scanning velocity values for the maximum and zero amplitudes and the frequency of capillary waves. A comparison between calculated curves and experimental data confirms both the capillary origin of the pores and the estimated scanning speeds at which the parameters of the pores exhibit their maximum values or vanish. The results obtained may facilitate in the selection of the optimal scanning speed when designing a pore-free technology.
- Добавил в систему: Мирзаде Фикрет Хансуварович