Influence of Silicon on the Properties of Aluminum Alloy Powders of the Silumin Type and the Mechanical Properties of Products Made from These Powders by Selective Laser Melting

Ryabov, D.K.; Kozlov, D.A.; Petrov, A.K.; Garshev, A.V.; Evdokimov, P.V.; Filippov, Y.Y.; Orlov, N.K.; Putlyaev, V.I.; Chetvertukhin, A.V.; Krokhin, A.Y.; Khromov, A.P.; Korolev, V.A.; Mikhailov, I.Y.

Авторы: Ryabov D.K., Kozlov D.A., Petrov A.K., Garshev A.V., Evdokimov P.V., Filippov Ya Yu, Orlov N.K., Putlyaev V.I., Chetvertukhin A.V., Krokhin A.Yu, Khromov A.P., Korolev V.A., Mikhailov I.Yu
Журнал: Theoretical Foundations of Chemical Engineering
Том: 54
Номер: 5
Год издания: 2020
Издательство: Maik Nauka/Interperiodica Publishing
Местоположение издательства: Russian Federation
Первая страница: 1031
Последняя страница: 1039
DOI: 10.1134/s004057952005019x
Аннотация: Technologies for the 3D printing of metallic powders are being increasingly extensively used around the world as alternatives to casting and machining to manufacture components of complex shapes and prototypes. Silicon-alloyed aluminum alloys are the most widely used materials in the selective laser melting technologies, which is caused by the price of these alloys and their high manufacturability for the layer-by-layer fused deposition, owing to their low susceptibility to hot cracking under thermal and shrinkage stresses. High rates of cooling the melt facilitate the formation in the material of ultradispersed silicon-containing phases, which results in increased strength. In the article, exemplified by two cast alloys (AK7ch and AK9ch), the speeds of the process of building up the products by the selective laser melting technology have been determined at a laser-beam power of 300 and 325 W and an energy density within the range 89–32 J/mm3. It is shown that, for the AK9ch alloy, lower porosity values are achieved within the investigated energy density range when compared with the AK7ch alloy and better mechanical properties of the alloy with a higher silicon content are achieved within the range of lower laser-beam energy densities than for the alloy with a lower silicon content. The mechanical properties of the materials produced under the optimal selective laser melting conditions comply with the most stringent requirements for the mechanical characteristics of the castings of the AK7ch alloy upon heat treatment.
Добавил в систему: Евдокимов Павел Владимирович

	ИСТИНА	Войти в систему Регистрация
	ИСТИНА ИНХС РАН
	Главная Поиск Статистика О проекте Помощь

ИСТИНА

ИСТИНА ИНХС РАН

Influence of Silicon on the Properties of Aluminum Alloy Powders of the Silumin Type and the Mechanical Properties of Products Made from These Powders by Selective Laser Meltingстатья